Quiz ATPL | Page 5 | AGK - Instrumentation

During a final approach, the flight director system is engaged in the LOC mode (holding of localizer axis). The position of the vertical command bar indicates:	4 Answers
The block diagram of an auto-pilot is shown in the annex.For each control channel (pitch, roll and yaw) the piloting law is the relationship between the deflection of the control surface commanded by the computer (BETA c) and the:	4 Answers
A pilot engages the control wheel steering (CWS) of a conventional autopilot and carries out a manoeuvre in roll. When the control wheel is released, the autopilot will:	4 Answers
When being engaged, and without selecting a particular mode, an automatic pilot enables:	4 Answers
During a category III automatic approach, the position signals in the vertical plane under 200 ft are based on:	4 Answers
An airplane is in steady cruise at flight level 290. The auto-throttle maintains a constant Mach number. If the total temperature increases, the calibrated airspeed:	4 Answers
When flying in cold air (colder than standard atmosphere), indicated altitude is:	4 Answers
The response time of a vertical speed detector may be decreased by adding a:	4 Answers
A pitot tube covered by ice which blocks the ram air inlet will affect the following instrument (s):	4 Answers
To be as accurate as possible, an anemometer must be calibrated according to the following formula:	4 Answers

ATPL - Airline Transport Pilot license - Aircraft General Knowledge - Instrumentation Page 5